The depth of the substance is 4 mm gidpostroy.ru.

If you want, you are able to increase the length of the structure to 6 metres or more. To try it, it’s enough to attach a two-meter expansion. When picking a drawing, look closely at the distance between the arches. This figure must be 65 cm, which is the most appropriate length for the specified depth of the material. The width of the doors according to the manufacturer’s drawing is 90 cm.

Before building a polycarbonate greenhouse, it is necessary to select a location for its location. If that is done properly, it is possible to provide yourself with a crop of fresh vegetables for the entire calendar year.

The location for your upcoming greenhouse is marked immediately at the planning of the garden plot. So as to melt the snow in the location of the greenhouse as soon as possible, the very best point on the site will be a small elevation. In addition, in such a place will not need to be worried about significant humidity as soil and air in the construction.

Assemble a polycarbonate greenhouse on a raised site – means to care for the optimal temperatures indoors.

When it is not possible to place a greenhouse on an elevated position, you’ll have to pour a coating of fine shattered rock about 20 cm and the same layer of fertile soil to make seedbeds.

Before assembling a greenhouse on your backyard plot, it’s also wise to think about where and how this structure is going to be installed. First, you have to select a location for this. The greenhouse should be found at a well-lit area at least a few meters away from homes, barns and other structures.

How to install a greenhouse in Line with the Surfaces of the Planet

Make sure you measure the dirt surface – it’s best to remove the surface. This can also get rid of weed seeds. And for ease of work, remove the dirt in an area that is around a meter wider on all sides of the rectangle you want.

It’s also worth considering having a base. As manufacturers state, now most greenhouses do not need it, particularly if they (greenhouses) are used just in the summer and spring period. But, seasoned anglers still suggest earning a basic foundation from a bar. It’s extremely simple – it is sufficient to associate with each other utilizing metal corners and screws four parts of timber using a cross-section of at least 10 * 10 cm. The dimensions of such a foundation should be equivalent to the foundation of their upcoming greenhouse.

Simple bar base

You can also create a strip foundation of concrete. He is more dependable than a bar base, but demands greater financial and labour costs. Incidentally, the rainwater, which is utilised in the winter, with no and do not do without it whatsoever.

Stages of the creation of a strip base: a schematic representation

Many manufacturers counsel to put in greenhouse structures without even building a foundation. Even for this intention, they equip the framework with special T-shaped legs, so that the construction was securely fixed. But, as practice shows, it is still crucial to construct a base: so and the basis will be more rigorously fixed and also the components of the basis in contact with the ground, will be stored much more in its initial condition.

The most important issue is to take care of the material with special agents to protect the wood from moisture. The material is usually installed on concrete cubes which are dug into the ground. For a six-meter structure, they want 10 pieces: four to either side and one in the middle of the endings.

Before you do the greenhouse , you will need to select the right place for this. It must be an even site, so that the frame was found evenly, without distortions. It should be bright and not obscured by trees or buildings.